NOS (New-Old Stock) Dia-Compe "pull up" bolt for band clamps on 140's, 150's, and 160's series model drop bar brake levers. These were also used on the 138 touring brackets for drop bar handlebars. Typically these parts will also fit Weinmann products that use the same model number. The 2nd photo shows a diagram with where this part goes on the lever.
Dia-Compe part number: 144.5
Material: Steel
Size: M6 x 0.75 threading (this is my best guess - it is much finer than M6 x 1.0 and made in Japan, so premumably it is 0.75 thread pitch). Bolt length is 25mm (not including the head, which is how bolt length is measured - overall length is 30mm). The unthreaded shank is 5.81mm and 10.3mm of the length.
These came in sealed Dia-Compe shop packs with 10 bolts each. If you order 10 bolts (or multiples of 10) you will receive them in the original bags. If you order less than 10 or any not in a multiple of 10, you will receive them in sealed, plain plastic bags.
SOLD INDIVIDUALLY (as shown)
MADE IN JAPAN
Theme by InStijl Media